News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
What causes the board‑slipping phenomenon in CNC cutting machines?
Release Date:
2026-06-28 12:04
CNC cutting machine Board warping is a fairly common issue in everyday production, and those of you who work with panel furniture have likely encountered it. So what causes this phenomenon? Our staff will provide an analysis below—please use it as a reference only.

1. Insufficient suction from the vacuum pump: Insufficient suction is the primary cause of board‑slippage in CNC panel‑cutting machines. The vacuum pump is essential for holding the workpiece securely on the machine table. To troubleshoot, first turn off all vacuum valves, then start the vacuum pump and check the pressure indicated by the vacuum gauge. Under normal conditions, the gauge needle should deflect to the left; if it does not, sequentially open each vacuum valve and observe the corresponding gauge reading to identify which section of the piping may be leaking.
2. Deep scratches on the platform or an unclean worktable: In general, the depth of surface scratches on the platform can affect the material‑holding force of the sheet; severe scratches may even cause the sheet to slip. Additionally, the cleanliness of the worktable is another key factor influencing the CNC panel‑cutting machine’s ability to securely hold the material. Therefore, it is essential to clean the platform surface regularly, keeping it clean and smooth, and to inspect for excessively deep scratches, repairing or replacing the platform as needed.
3. Temperature: In some regions, temperature fluctuations can be significant. When operating a CNC cutting machine, parameters set in the morning may drift by afternoon—often due to thermal effects. For instance, the base plate may settle as temperatures rise: it’s rigid in the cooler morning hours but softens in the warmer afternoon, causing it to sag under suction. Using the original settings at this point can result in material misalignment or incomplete cuts.
That's all. CNC cutting machine The reasons for board wear—hopefully this will be helpful to everyone. We also encourage you to pay close attention to safety and proper maintenance during use, so as to extend the board’s lifespan.
Keywords:
CNC cutting machine