News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
What malfunctions do the four types of sounds emitted by a CNC cutting machine indicate?
Release Date:
2026-06-28 12:16
In CNC cutting machine During machining, the high-speed spindle is a critical component that plays a pivotal role; however, it is also prone to malfunctions and can sometimes generate significant noise. If the cutting machine emits a buzzing sound during operation, this indicates a problem with the spindle, preventing it from performing its tasks under load. The spindle should be replaced or repaired.

During operation, the spindle sometimes produces noise, and at other times it does not; the sound is intermittent. This is primarily caused by surface waviness on components of the CNC panel‑cutting machine. To address this, it is necessary to improve the machining quality of the bearing raceways and enhance the precision of the shaft and bearing housing assembly. So, in practical applications, how should we handle the noise emanating from the spindle?
I. Impurity Sounds
Caused by bearings or poor cleanliness, it produces irregular abnormal noises—sometimes absent, sometimes loud, sometimes faint—and is frequently observed in high-speed motors.
Solution: Select an appropriate grease, enhance cleanliness prior to greasing, improve the bearing’s sealing performance, and maintain a clean installation environment.
II. The Buzzing Sound
When the motor runs under no-load conditions, it emits a buzzing sound similar to a beep, and exhibits abnormal axial vibration; a humming noise is also heard during startup or shutdown.
Solution: This phenomenon typically occurs when lubrication is inadequate, particularly in winter, and in motors with ball bearings at both ends. It arises as an unstable vibration caused by axial vibrations, often due to poor shaft self‑aligning performance.
III. The Sound of Tapping
The sound frequency varies with the bearing’s rotational speed, and surface waviness of the components is the primary cause of noise.
Solution: Improve the surface finish of the bearing raceway to reduce wave amplitude, minimize impact, adjust preload and clearance fits, inspect the operating condition of the free-end bearing, and refine the installation methods for the shaft and bearing housing.
IV. The Pattering Sound
It is generated by vibration and impact between the cage and the rolling elements, and is independent of the grease type; it is more likely to occur when bearing torque, load, or radial clearance are large.

Solution: Improve cage precision, select bearings with smaller clearance or apply preload to the bearing, reduce torque loads, and minimize installation errors. CNC cutting machine The manufacturer recommends using a high-quality grease.
Keywords:
CNC cutting machine