News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
Want your CNC cutting machine to be highly efficient? Don’t overlook these ten key points!
Release Date:
2026-06-28 12:16
Nowadays, most furniture manufacturers are accustomed to using Jinan CNC Cutting Machine This helps optimize scheduling and save materials and time. Like humans, machines require regular maintenance; otherwise, minor issues can accumulate over time and turn into major problems. So, let’s take a look at what aspects need attention when maintaining a cutting machine!

1. Before starting the equipment, first check that the wiring is intact and the voltage is stable, then turn on the machine’s power. Before commencing processing, run the machine for a short period.
2. There are two types of spindles for cutting machines: air-cooled spindles and water-cooled spindles. Water-cooled spindles require clean cooling water and a properly functioning pump. It is important to note that water-cooled spindles must never run low on water.
In addition to the maintenance tasks mentioned above, pay close attention to the coolant temperature. If the coolant temperature becomes too high, the cooling efficiency will be significantly reduced, potentially causing some degree of damage to the spindle; therefore, replace the coolant promptly. During winter, implement antifreeze measures to prevent pipes from freezing and cracking.
3. Regularly clean the cooling and ventilation system of the Jinan CNC cutting machine’s electrical cabinet, verify that all fans are functioning properly, periodically remove dust from inside the control cabinet, and check that terminal screws are securely tightened to ensure the safe and reliable operation of the electrical circuitry.
4. Promptly remove wood chips from the guide rails and surrounding areas, and lubricate the equipment’s drive system as needed.
5. Promptly clean dust, powder, and oil residues from the sensor.
6. After CNC machining, first retract the cutting tool and allow the spindle chuck to loosen. This helps extend the service life of the spindle chuck.
Next, we begin cleaning the work surface using a brush; be sure not to pile up debris on the surface to prevent deformation. Move the machine head to the lower-left or lower-right parking position to avoid collisions, then disconnect the power supply.
7. If not used for an extended period Jinan CNC Cutting Machine Power the equipment once a week to prevent moisture buildup and ensure the stable, reliable performance of its electrical components.
8. Avoid opening cabinets frequently. When cutting materials, the air typically contains dust, wood shavings, or metal particles. If these settle on circuit boards or electronic components inside electrical cabinets, they can easily reduce insulation resistance between components and even damage the components and the circuit board.
9. Regularly inspect all screws on the CNC cutting machine to ensure they are securely tightened.

10. Maintenance of the vacuum pump: The metal mesh at the inlet of the water‑circulation pump is designed to prevent dust from entering; the filter should be kept clean at all times to avoid clogging, which can reduce the pump’s flow rate. When the pump is not in use, it should be powered on for a few minutes each week to prevent rusting and ensure proper operation.
Keywords:
Jinan CNC cutting machine