News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
How can the vacuum pump of a woodworking panel‑cutting machine be effectively maintained?
Release Date:
2026-06-28 12:16
Woodworking panel saw The application of such systems has become a market trend, comprising numerous critical components, each of which is essential to the proper operation of the equipment. Consequently, component maintenance is of paramount importance. Next, we will explain how to maintain the vacuum pump of a cutting machine during its operation.

1. To prevent wear on the impeller and pump casing or impeller blockage, any particulate matter carried into the pump chamber with the gas and working fluid should be flushed out through the flushing port at the bottom of the pump cover.
2. If hard water is used as the working fluid, it must be softened, or the vacuum pump should be periodically cleaned with a solvent.
3. Lubrication: Under normal operating conditions, when using a 50 Hz motor, after 20,000 hours of operation or three years, the old grease and any contaminants in the bearing and its surrounding housing should be removed, and fresh grease should be applied. The cleaned grease should fill approximately 50% of the bearing’s free space and 65% of the clearance between the bearing caps. If operating conditions are severe, the grease‑change interval should be shortened accordingly.
4. Once the exhaust port is completely empty, open the tank’s outlet to allow the liquid to drain. Then, manually rotate the fan to turn the vacuum pump until no more liquid flows out. Tilt the pump at a 45-degree angle; this will essentially evacuate the pump. In this way, even if the vacuum pump remains idle for an extended period or in cold weather, it will not be damaged.
5. Procedures for long-term pump shutdown: If the vacuum pump is to remain idle for approximately four weeks, it should be completely drained in accordance with item 3 in advance, followed by corrosion protection. Specifically, pour 0.5 liters of anti-corrosion oil into the pump through either the inlet or outlet, then run the pump briefly. If the pump has been shut down for an extended period due to hard water and the impeller becomes seized, fill the pump chamber with a 10% oxalic acid solution for about 30 minutes.
6. Please check whether the vacuum pump of the opener is generating insufficient negative pressure:
a. Is the ball valve open?
b. Is the pipeline between the water tank and the pump body blocked by scale?

Woodworking panel saw The vacuum pump is essential to the operation of the panel‑cutting machine; therefore, it is crucial to perform proper maintenance on this component and to give it the attention it deserves. Only then can you ensure optimal operational efficiency and superior processing quality.
Keywords:
Woodworking panel saw