News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
A Must-Read for Beginners: Seven Key Precautions for Operating a Dual-Station CNC Cutting Machine!
Release Date:
2026-06-28 12:14
In today’s furniture market, Dual-station CNC cutting machine The number of such machines has increased significantly, moving away from traditional manual processing and effectively boosting the efficiency of board‑processing operations. However, operating CNC equipment requires not only a solid grasp of basic operational skills but also careful attention to safety and procedural guidelines—especially when using a panel saw. So, what key precautions should operators observe? Let’s take a look.

1. Operators must undergo specialized training on the cutting machine, gain a systematic understanding of its component configurations, and master the operating procedures and standards.
2. Before starting the cutting machine, perform a thorough inspection of its transmission system, operating system, lubrication system, and verify that all critical components are securely fastened. Only proceed with startup after confirming that the equipment is in proper working condition.
3. After the cutting machine is started, it should be run at idle for adjustment; only after confirming normal operation may sheet‑metal processing commence.
4. After the cutting machine has finished operating, blow away all dust from the entire equipment (the guide rails, rack, and Z-axis lead screw are critical components that require thorough cleaning). Then, wipe the guide rails and rack clean with a cloth, and apply machine oil to them using a brush.
5. For equipment equipped with a water‑circulating vacuum pump, drain all the water from the chamber (if there is any residue at the bottom, rinse it thoroughly with clean water). Remove the three plugs beneath the pump cover, tilt the water tank forward by 45 degrees, and drain all the water.
6. Remove the dust bag from the vacuum cleaner, empty it thoroughly, and then reinstall it.
7. After the cutting machine has been properly maintained, cover it with a plastic bag to prevent dust from settling.

Dual-station CNC cutting machine The seven key operational precautions cover both the operation and subsequent maintenance of the panel saw, and are extremely detailed and effective. When using the panel saw, refer to the above guidelines to enhance processing efficiency and extend the machine’s service life.
Keywords:
CNC cutting machine