Welcome to visit the official website of Shandong Sudiao Intelligent Equipment Co., Ltd.

 中文 | Admin  |  Home

The Practitioner of automation application solutions in the woodworking industry

Customized Production, Super Quality, Worry-Free Service

Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.

News Center

Contact Information

Business Department:

Sales Manager: Juan Liu

Tel : +86-531-88271994

Mob:+86-13305314695

E-mail:sales@sudiao.com

E-mail:juan@sudiao.com 

WhatsApp&weChat:

Juan: 0086-13305314695

Welcome to your consultation and corporation.

Contact us if you're interested in our products or you need technical support.

 

How do you maintain the vacuum pump of a woodworking panel‑cutting machine? Learn how now!


Release Date:

2026-06-28 12:13

   Woodworking panel saw How should a vacuum pump be maintained? We believe this is a question that many panel‑furniture manufacturers are keen to address. But how much do you really know about it? Let’s dive in together with a panel‑furniture manufacturer to explore effective maintenance practices for vacuum pumps, and we hope this will prove helpful.

 Woodworking panel saw

  Water addition: Every morning—before midday processing—check that the water level in the tank is at least three-quarters full or just below the filter screen; it must not fall below one-third. If the level is low, replenish it promptly to prevent plate misalignment. Regularly (every 15 to 30 days), clean the vacuum pump and the interior of the chamber; over time, sediment will accumulate, so draining the water can help reduce sediment buildup and protect the pump. In winter, drain the water daily or add antifreeze to prevent the vacuum pump from freezing and being damaged.

  Oil–water separator: Check daily whether the water level in the sight glass of the oil–water separator and the air compressor is full, and drain it promptly if it is.

  Drill rig maintenance: Add lubricant, 5 mg per week.

  Perform a monthly inspection of the machine’s screws, and tighten any that have become loose promptly (avoid excessive torque to prevent stripping the threads) to prevent loosening from compromising accuracy.

  In winter, be sure to preheat before drilling:

  When starting the drill rig each day, it is recommended to perform a slow no‑load warm‑up to allow the bearings to gradually reach their operating temperature. This ensures that thermal expansion of the bearing housing rings is evenly distributed and that an appropriate preload is achieved. The following warm‑up procedure is advised; no actual machining (no‑load) is required.

  Run the drilling unit at 3,000 rpm for 5–10 minutes. During this time, all vertical and horizontal spindles must retract one by one and hold their working positions for 1 second. This sequence must be repeated throughout the entire process.

  After the thermal cycling procedure is completed, the outer surface temperature of the drill must exceed 25°C. If this temperature is not reached, repeat the preceding step in the above sequence.

 Woodworking panel saw

  In summary! We believe that, based on the above, everyone has a better understanding of… Woodworking panel saw We now have a much deeper understanding of the proper maintenance of vacuum pumps. For panel‑cutting machines, vacuum pumps are of paramount importance—they not only affect the equipment’s operation but also directly impact product quality.

Keywords:

Woodworking panel saw