Welcome to visit the official website of Shandong Sudiao Intelligent Equipment Co., Ltd.

 中文 | Admin  |  Home

The Practitioner of automation application solutions in the woodworking industry

Customized Production, Super Quality, Worry-Free Service

Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.

News Center

Contact Information

Business Department:

Sales Manager: Juan Liu

Tel : +86-531-88271994

Mob:+86-13305314695

E-mail:sales@sudiao.com

E-mail:juan@sudiao.com 

WhatsApp&weChat:

Juan: 0086-13305314695

Welcome to your consultation and corporation.

Contact us if you're interested in our products or you need technical support.

 

What factors contribute to significant machining deviations between the front and back sides of a CNC cutting machine, and how can these be addressed?


Release Date:

2026-06-28 12:11

  In the process of custom furniture manufacturing, it is sometimes found that using… CNC cutting machine After cutting the material, significant deviations between the front and back sides result in poor installation of our cabinets, leading to misalignment and non‑compliant fitting. What causes this issue? Let’s analyze it:

 CNC cutting machine

   Generally speaking, there are several reasons:

   1. The workpiece coordinates are inaccurate. This is quite common. The solution: simply reset the workpiece coordinates for the X and Y axes, provided that the diagonal and the locating cylindrical surfaces have already been properly adjusted; otherwise, it will not correspond to the white tone.

   2. Spindle offset is incorrect Incorrect material cutting and other spindle misalignments can lead to positional deviations. In such cases, you typically observe overall shifts in slotting and drilling operations. When only the front side is machined, the positions of slots and holes are also off—not merely due to simple positive or negative machining tolerances. This issue commonly occurs on multi‑station blanking machines.

  Solution: Adjust the spindle offset, drill several spindles in the same location one after another, and determine the deviation value.

   3. The diagonal is inaccurate. It goes without saying that the diagonal is crucial for the initial setup. If the cutting machine’s diagonal error is too large, the front hole and front slot will be highly accurate, while the rear hole and front slot will exhibit greater deviations.

  Solution: Adjust the diagonal. For 1200×2400 mm large panels, the diagonal deviation shall not exceed 0.5 mm.

   4. Identify the cause of cylinder damage. The front and rear positioning cylinders of the material‑feeding machine cannot form a 90° angle, and the sheet‑placement process fails to achieve proper alignment. While this issue has little impact on single‑sided machining, it can be fatal for turnaround‑type operations.

  Solution: Adjust the positioning cylinder. You can use the spindle’s linear motion to verify that the positioning cylinder is aligned in a straight line. Note that the diagonal must be properly adjusted; otherwise, the result will appear white.

   5. The machine clearance is too large. If the error during machine operation is too large, the position of each individual hole will be inaccurate.

  Solution: Adjust the rack clearance and the reducer clearance, and replace the slider.

 CNC cutting machine

  How to solve it CNC cutting machine When cutting materials, if the front‑to‑back processing deviations are excessively large, the first step in practice is to identify the root causes of these discrepancies based on the specific situation, so that appropriate corrective measures can be implemented. We sincerely hope that the above guidance will help everyone resolve this issue effectively.

Keywords:

CNC cutting machine