Welcome to visit the official website of Shandong Sudiao Intelligent Equipment Co., Ltd.

 中文 | Admin  |  Home

The Practitioner of automation application solutions in the woodworking industry

Customized Production, Super Quality, Worry-Free Service

Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.

News Center

Contact Information

Business Department:

Sales Manager: Juan Liu

Tel : +86-531-88271994

Mob:+86-13305314695

E-mail:sales@sudiao.com

E-mail:juan@sudiao.com 

WhatsApp&weChat:

Juan: 0086-13305314695

Welcome to your consultation and corporation.

Contact us if you're interested in our products or you need technical support.

 

Does the woodworking panel saw leave burrs when cutting? What causes this?


Release Date:

2026-06-28 12:11

   Woodworking panel saw Today, its applications are becoming increasingly widespread, and its production quality is widely recognized, earning it strong support from major panel‑furniture manufacturers. Nevertheless, issues can still arise. Below, we briefly outline the four main reasons why CNC‑cut板材 may develop burrs.

 Woodworking panel saw

   I. Blade Sharpness

  A cutting machine uses cutting tools to perform material cutting, and the sharpness of these tools directly affects the surface roughness of the cut. If the tools are not sufficiently sharp, the material may chip or splinter upon切入; therefore, it is not advisable to run the machine at high speeds when the tools are in poor condition.

   II. Raw Materials for Panels

  The板材 used for cutting include MDF and particleboard. Both have relatively high hardness, but thanks to their low cost and ease of processing, they are widely employed in edge‑banding applications for panel furniture. However, these two materials share a common drawback: they are both manufactured by compression, meaning they are not monolithic. If the adhesive bond is not sufficiently strong, the edges can easily collapse at the moment of cutting.

   III. Spindle Speed

  This is similar to the sharpness of the cutting tool. If the spindle speed is too low, the板材 (sheet material) being cut by the panel‑cutting machine will collapse very easily. Increase the spindle speed, but be sure to adjust it within a range that does not compromise the tool’s performance.

   4. Tool clamping is insecure.

  The tool holder on the woodworking panel‑cutting machine is not securely clamped, which can cause edge chipping of the板材 and damage to the cutting tools during processing.

 Woodworking panel saw

   Woodworking panel saw Its introduction has effectively addressed the shortcomings of traditional panel‑cutting methods, significantly enhancing both the efficiency and quality of panel furniture production. However, inadequate daily operation and insufficient equipment maintenance can lead to production issues; therefore, it is essential to prioritize proper operating procedures and routine maintenance.

Keywords:

Woodworking panel saw