News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
Does a CNC cutting machine need adjustment after a period of use? If so, how should it be adjusted?
Release Date:
2026-06-28 12:09
Any machine will exhibit a certain degree of error after a period of use. CNC cutting machine This is no exception. Therefore, it is necessary to perform regular adjustments on machinery and equipment to ensure precision. The following sections provide a detailed overview of the adjustment procedures.

Specific adjustment procedures for the CNC cutting machine:
1. Adjustment of the cutting machine’s conveyor belt
First, start the cutting machine; the worktable can be raised to engage the abrasive belt. Each pass on the conveyor belt should not exceed 0.1 mm to prevent belt deformation. After adjustment, remove any worn debris and set the thickness to zero.
2. Adjustment of the thickness-setting roller
Adjust the height of the worktable. After removing the abrasive belt, place the 60–80 grit sandpaper template on the conveyor surface, raise the worktable so that the sandpaper lightly contacts the roller, and move the template back and forth along the length of the rebar. Once adjusted, remove the chip and set it to zero.
3. Adjustment of the pressure roller
Raise the sanding pad, remove the abrasive belt, lift the worktable, gently touch the conveyor belt with the thickness‑setting roller, and then adjust the worktable according to the thickness reading until the pressure roller lightly contacts the conveyor belt and the nut is tightened.
4. Abrasive Belt Swing Adjustment
It is controlled by photoelectric switches, and the oscillation reference point is adjusted by positioning the abrasive belt. Typically, the protective fiber of the abrasive belt is positioned approximately 1 cm from the rod’s edge and is monitored by two pairs of photoelectric sensors. The reference point is set at the rod’s edge, where the system halts.
5. Leveling with sand pads
Raise the sanding pad, remove the abrasive belt, place the spirit level on the conveyor belt, and lift the worktable until the thickness‑adjustment roller lightly contacts the level. Then slide the leveling ruler from one end of the sanding pad to the other to check its horizontal alignment; if any deviation is detected, adjust it by turning the left‑ and right‑hand threaded screws on the sanding pad.
6. Display Zeroing
The CNC cutting machine is pre‑zeroed at the factory. After adjusting the table’s flatness and polishing the conveyor belt and thickness‑setting rollers, the thickness display must be reset to zero.
CNC cutting machine Its introduction has enhanced the production efficiency and processing quality of panel furniture. However, as a CNC machine, it inevitably accumulates errors after prolonged operation. Therefore, periodic recalibration is necessary to ensure long-term performance.
Keywords:
CNC cutting machine