Welcome to visit the official website of Shandong Sudiao Intelligent Equipment Co., Ltd.

 中文 | Admin  |  Home

The Practitioner of automation application solutions in the woodworking industry

Customized Production, Super Quality, Worry-Free Service

Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.
Shandong Suku Intelligent Equipment Co., Ltd.

News Center

Contact Information

Business Department:

Sales Manager: Juan Liu

Tel : +86-531-88271994

Mob:+86-13305314695

E-mail:sales@sudiao.com

E-mail:juan@sudiao.com 

WhatsApp&weChat:

Juan: 0086-13305314695

Welcome to your consultation and corporation.

Contact us if you're interested in our products or you need technical support.

 

How should the vacuum pump of a CNC cutting machine be maintained and serviced?


Release Date:

2026-06-28 12:08

   CNC cutting machine The application of vacuum pumps has become a market trend. A complete machine is composed of numerous critical components, yet these parts can encounter certain issues during continuous operation. The following sections will primarily explain how to maintain the vacuum pump of a panel‑cutting machine during use.

 CNC cutting machine

  1. To prevent wear on the impeller and pump casing or impeller jamming, flush out dust particles that have entered the pump chamber along with the gas and process fluid through the flushing port at the bottom of the pump cover.

  2. If hard water is used as the working fluid, it should be softened regularly or the vacuum pump should be cleaned with a solvent.

  3. Lubrication: Under normal operating conditions, when using a 50 Hz motor, after 20,000 hours of operation or at most three years, the bearing and adjacent cavities should be cleaned of spent grease and contaminants, and then replenished with fresh grease. The amount of grease injected should fill 50% of the bearing’s free space and 65% of the clearance between the bearing cover and the housing. If operating conditions are extremely severe, the grease‑change interval should be shortened accordingly.

  4. During venting, open the water tank outlet to allow the liquid to drain. Then, manually rotate the fan to drive the vacuum pump until no liquid remains. Tilt the pump at a 45-degree angle to thoroughly evacuate it. This prevents damage to the pump even if it is left idle for an extended period or exposed to cold weather.

  5. Procedure for long-term pump shutdown: If the vacuum pump is to remain idle for approximately four weeks, it should be completely drained in accordance with Section 4 well in advance, followed by corrosion protection. To do this, inject 0.5 liters of anti-corrosion oil into the pump through the inlet or outlet, then run the pump briefly. If, due to the use of hard water, the impeller becomes seized after a prolonged shutdown, fill the pump chamber with a 10% oxalic acid solution for about 30 minutes.

  6. If the CNC cutting machine’s vacuum pump has insufficient negative pressure, please check.

  a. Is the ball valve open?

  b. Is the pipeline between the water tank and the pump body blocked by scale?

  The vacuum pump is in CNC cutting machine It plays a crucial role during operation, so regular maintenance is essential to ensure the equipment functions properly and to extend its service life to some extent.

Keywords:

CNC cutting machine