News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
What precautions should be observed when using a fully automatic cutting machine?
Release Date:
2026-06-28 12:07
Fully automatic cutting machine It is an essential piece of equipment for furniture manufacturers undergoing a transition toward smart and automated production, helping them boost processing efficiency and strengthen their core competitiveness. However, in practical use, there are certain precautions that must be observed when operating a panel‑cutting machine; failure to do so can damage the equipment and disrupt normal operation. Only by mastering the operational guidelines for fully automatic panel‑cutting machines can optimal processing results be achieved.

Precautions to observe when using a fully automatic cutting machine:
1. Blindly adding certain things
Adding lubricant to a fully automatic cutting machine is not a simple task; it involves applying fundamental principles from fluid mechanics, solid mechanics, materials science, applied mathematics, and physical chemistry to study lubrication mechanisms, lubricants, and lubrication techniques, as well as methods for controlling harmful substances and reducing friction and wear in equipment. Therefore, do not arbitrarily introduce any substances into the machine. Lubrication for a piece of equipment must be maintained throughout its entire lifecycle—starting from the design phase and continuing after the equipment has been put into service.
2. Excessive addition
In short, lubricating oil is applied between the two friction surfaces of a device to form a thin oil film that prevents direct contact and thereby reduces wear. However, certain side effects associated with the lubricant’s surface must be taken into account, so the amount of oil added should be carefully controlled. For example, in gear reducers, to minimize gear‑motion resistance and ensure stable oil circulation, the oil immersion depth is typically 1 to 2 tooth heights. Accordingly, it is recommended that the oil level be kept lower for high‑speed applications.
3. Selection of Lubricants
The type and grade of lubricant should be selected based on factors such as the operating conditions, working environment, specific characteristics, and lubrication method of the friction surfaces of the fully automatic cutting machine. For equipment operating at high speeds with strong oil‑film formation, low‑viscosity lubricating oil is recommended; when the unit area load on the friction surfaces is relatively high, a high‑viscosity lubricant with excellent oiliness should be used; and at elevated operating temperatures, lubricants with high viscosity, a high flash point, good oiliness, strong thermal stability, or a high dropping point are preferred. The smaller the clearance between the friction surfaces of the fully automatic cutting machine, the lower the viscosity of the selected lubricant; conversely, the rougher the friction surfaces, the higher the viscosity of the lubricant should be. If the grease cone angle is to be small, the oil temperature should be relatively high, and a lubricant with higher viscosity should be employed.
Therefore, during operation, the lubricant should be selected in strict accordance with the aforementioned principles and test results. Under normal circumstances, the type of lubricant should not be changed arbitrarily; otherwise, the equipment’s lubrication conditions may be compromised, leading to increased wear and even financial losses.
In summary, using Fully automatic cutting machine A major taboo is the selection and addition of lubricant. Choose a lubricant that matches the equipment’s specifications, and do not switch to a different type during operation or add any additives arbitrarily; otherwise, the cutting machine’s normal performance may be compromised.
Note: The technical content above is for reference only.
Keywords:
Fully automatic cutting machine