News Center
Contact Information
Business Department:
Sales Manager: Juan Liu
Tel : +86-531-88271994
Mob:+86-13305314695
E-mail:sales@sudiao.com
E-mail:juan@sudiao.com
WhatsApp&weChat:
Juan: 0086-13305314695
Welcome to your consultation and corporation.
Contact us if you're interested in our products or you need technical support.
A woodworking panel‑cutting machine manufacturer shows you how to effectively prevent tool damage—worth saving!
Release Date:
2026-06-28 12:15
When furniture manufacturers use CNC panel‑cutting equipment to process板材, they inevitably employ a variety of cutting tools. Different materials and machining processes call for different tools; otherwise, the quality and precision of the work will be severely compromised. Therefore, Woodworking panel cutting machine manufacturer Please note that the proper use and selection of cutting tools for panel saws are of utmost importance. Next, the panel saw manufacturer will share tips on how to effectively prevent damage to your panel saw blades!

I. Workpiece Clamping
1. The板材 is not clamped securely and becomes loose. It is recommended to use a vacuum‑type panel‑cutting machine. If the clamps loosen easily, the板材 will vibrate, reducing precision; friction between the板材 and the cutting tool increases, causing the cutter and wood to scorch (turn black), diminishing the workpiece’s surface finish, and potentially leading to edge collapse of the板材 and shortened tool life.
2. The quality of the board affects the wood’s surface finish and the service life of the cutting tools!
The panel clamping is unstable; when cutting small workpieces, they tend to rebound and strike the cutter directly. Additionally, unstable clamping causes surface waviness on the workpiece edges during cutting, which adversely affects subsequent edge‑banding.
II. Selection of Tool Cutting Length
When the depth of cut is too large—for example, with a nominal plate thickness of 18 mm and a cutting length of around 22 mm—chip evacuation becomes poor when the cutting edge is below 20 mm. This leads to elevated cutting‑tool temperatures and thermal damage to the cutting edge (darkening), resulting in reduced tool life and severe fracture at the junction between the cutting edge and the tool body.
III. Equipment and Machine Control
1. The machine exhibits poor overall stability; its speed is not proportional to the thickness of the material being cut, and excessive load causes significant vibration during operation, with the clamping shaft also swinging. This poses a serious risk of breakage to both the workpiece and the cutting tool.
2. The machine’s operating speed is not proportional to the cutting tool’s load; repeated friction causes the tool to repeatedly strike the workpiece, which is also one of the reasons for tool breakage.
3. Pay attention to the timing belts on both sides of the machine. If one side is worn, it should be replaced promptly.

IV. Power-On Self-Test
Please inspect in advance when processing wood:
1. Ensure the fixture and clamping tools are securely fastened. Before use, blow out any debris from the fixture and inspect the chuck for wear or impact damage to prevent insufficient clamping, clamping misalignment, or slippage.
2. Verify that the sheet material is securely clamped and that the tool holder and collet are in good working condition.
3. It is crucial that the depth setting of the tool holder remains stable.
4. In summer, the hot weather causes the vacuum pump to overheat, leading to insufficient vacuum pressure, reduced clamping force on the workpiece, and loosening of the sheet material.
5. Woodworking panel cutting machine manufacturer It is recommended to promptly clean and replace any damaged base plates to ensure adequate suction.
Keywords:
Woodworking panel cutting machine manufacturer